Since 2008 New product SDV-HLA (AAC:Automatic Attachment Change)

1. CONTROLLER: FANUC 18IMB
2. STROKES: X-4200mm Y-2900mm Z-1000mm
3. WORKING TABLE: 4000x2200mm
4. SPINDLE TYPE: 8,000rpm WITH Z.F. GEAR BOX,BT-50
5. HANGING TYPE OPERATING PANEL
6. TOOL MAGAZINE FOR VERTICAL & HORIZONTAL TOOL CHANGE
7. 「A.A.C」AUTO ATTACHMENT CHANGE-RIGHT ANGEL HEAD

Head Stock:

1. Head Stock Is Built Aside Of Column Which Is Same Side Of Operating Panel.
2. A Head Stock For Store Right Angle Head And Cover Of Vertical Spindle To Away From Chip And Dust.
3. For Single Head Auto Change Is Available With This Type Of Head Stock.If Auto Change Head More Than One, The Designation Shall Be Different.

Vertical & Horzontal Tool Change:

1. V&H tool magazine not only for vertical tool change, after autoattachment connected to vertical spindle, also can do tool change for right angle head.
2. It saves much time for operator, you do not have to do manual tool change,directly move the ram to fix position of tool change, then it can do tool change automatically.